Operating procedures for film winders

In order to make the film winder work well, you need to operate it in the correct way, so what is the specific operation method? Next, let's take a look at the operating procedures of the film winder. We divide it into six steps to introduce to you. I believe you will like the following content.

1. Press START to start cores A and B. When the film is broken, press INTRODUCTION to turn the core to the film-penetrating position (air knife side), and wrap it with tape.

2. When the film winder reaches the production speed and the corona treatment is normal, press CUTTING to change the roll, and the cutter automatically cuts the film.

3. After the outer core stops and the film is wound normally, press CHUCKS/OPEN to open the chuck, hoist the parent roll to the temporary unwinding table, hoist an empty core to the winder, and press CHUCKS/CLOSE to close the chuck .

4. Clean up the waste film on the roll core.

5. When changing the roll normally, the winder system will remind you to change the roll 5 minutes in advance. After the film is wound to the set length, press CUTTING to cut the film, and repeat the last three steps of this procedure.

6. Assist the laboratory personnel to hoist the parent roll to the aging treatment rack after sampling is completed.

The operating procedures of the film winder are introduced here. Society is developing, technology is developing, and enterprises are also developing. If an enterprise wants to have a position in the industry, it needs to continuously develop products that are popular with users. Enterprises need to spend more experience in innovation, so that they can develop better and better in the future.